[SOLVED] multistop shipment

[krishna.kk]

Hi,

Is it mandatory to enter Latitude and Longitude for the LOCATIONS involved in multistop even if the Rate Distance is Look up only

when I tried to create a multi stop from Order release >>Action >>Create Buy Shipment>>Multi stop

Below error is displayed


Failed to pair any two shipments.



In the itinerary should we only select “ “NO EQUIPMENT OPTION “ FOR Equipment Assignment Type to make the multi stop work .

Rgds,
kishore

[AlejandroBarba]

Re: multistop shipment

Hi Kishore,

Are your locations outside of the US? OTM should autopopulate the long-lat information based on the US Zip Code.

We have a multi stop itinerary with the option of Optimize Equipment (instead of No Equipment Option) and it works fine.

Some tips that may also help you are:
If your shipments is:
A(pick up) to B (pick up) to C (drop off),
Make sure that you have rate records for the following lines:
A to C
B to C
Make sure that a rate per mile can be used in either case (a rate per mile for each rate record or using the Circuitous Distance Cost).

I wonder if multistop works under a LookUp distance configuration but make sure that the distances from A to B and from B to C are also included in your lookup distance table.

Check the time windows on your order releases, there might be a time constraint there for a multistop.

Finally, sometimes we have had problems planning multi-stop shipments. We opted to plan 2 direct shipments that later can be
merged together in a multistop.

Hope this helps,

Alejandro Barba