Announcement

Collapse
No announcement yet.

Mutlti stop - A->B AND B->C

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Mutlti stop - A->B AND B->C

    Hi i have a senario as belowi have three location A,B,C .

    Two order release

    Order release 1- Location A - Location B

    Order release 2 - Location B - Location c

    Distance between LOCATION A - LOCATION B IS 100

    Distance between Location B -LOCATION C IS 90

    Rate Distance is lookup

    Itinerary - Multistop

    I need the truck to go from A-B and pick up the Second Order release from B-C

    When i tried to plan it says unable to pair any two shipment,

    Rgds
    kishore

  • #2
    Re: Mutlti stop - A->B AND B->C

    Hi Kishore,

    The distances are in the appropriate tabel?
    The rate service is setup correct? I mean whether the transit times in there are available.
    Best Regards,

    Bob Romijn

    Comment


    • #3
      Re: Mutlti stop - A->B AND B->C

      Reply yes . Evrthing is fine .

      Does this scenario come under multi stop or continous move in terms of OTM ?

      RGDS
      KISHORE

      Comment


      • #4
        Re: Mutlti stop - A->B AND B->C

        Hi,

        To me it can be both. But I do not like the CM, because it gave me more trouble then the Multistop routes.
        I never tried the route you mention. However I did:

        order 1: A -> B
        order 2: c -> D
        Shipment was then: A -> C -> B -> D
        I do think your sceanrio should also fit in this.
        Best Regards,

        Bob Romijn

        Comment


        • #5
          Re: Mutlti stop - A->B AND B->C

          kishore,

          I assumed you used the 'Bulk Plan' action,are the rate offerings which would qualify for this shipment in the multistop planning rates? This is located in Transportation Planning and Execution>Power Data>MultiStop Planning Rates.

          One more thing I just thought of, do you have a rate from A to C?

          Comment


          • #6
            Re: Mutlti stop - A->B AND B->C

            Hi Kishore,

            Were u able to resolve this scenario : A--> B & B ---> C.

            I have tried executing this scenario with my rate distances defined from A---B, B---C, C---B and since I have defined B and C under same state so defined another lane from State --- State as well.

            I don't see anything wrong with the master set ups. But still I got the message that no Itinerary defined for the geography.

            If this scenario is not working then I guess, we can do it only by defining continuous move or defining location B as consolidation pool.

            Please let me know ur experience.
            Regards
            Vipin

            Comment


            • #7
              Re: Mutlti stop - A->B AND B->C

              Hi Vipin i am not able to get it done using multistop . But i am able to do it using Continous move .

              Rgds
              kishore

              Comment

              Working...
              X