PC Miler setup in OTM

[MURTHYKO]

Dear Pals,

I done the PC Miler setup in OTM as shown in attached document.... It is not working..what can be the reason?

Cheers,
Lakshman

[nick.polites]

Re: PC Miler setup in OTM

Your configuration is incorrect. The PC Miler Host and port should say:

host pcmiler.host
port pcmiler.port

You then need to configure your glog.properties to point to Pcmiler's port and dns, then restart OTM. I would refer to the out of box PCMILER_PRACTICAL_CITY_TO_CITY if you want to create your own, or just use the out of box ones.

[MURTHYKO]

Re: PC Miler setup in OTM

DearNick,

I done that change some time back and tried, but I am getting a blank screen saying that "Distance Could Not Be Determined. Please refine your query and try again."

[nick.polites]

Re: PC Miler setup in OTM

Yes because out of box, you need to create a rate distance to use the external distance engine. Refer to help on how to set this up, but revert the changes back or remove the external distance engine you created.

[MURTHYKO]

Re: PC Miler setup in OTM

Dear Nick,

I done that too...Forgot to update in the document. Pls see the updated attached document and pass on your valuable suggestions.

[nick.polites]

Re: PC Miler setup in OTM

Did you check your glog.properties file to see if it is enabled? If it is run a telnet from your application server to the url and port to see if you have connectivity to the PC Miler server.